I'm a beginner and I'm programming with Code Composer. I would like to know how to use the digital-to-analog converter with a 0 to 3.3V output. I can only get it to work from 0 to 3V. Do I need to ...

i've been working with the SK-AM62 EVM for a couple of processor sdk versions. Currently im switching to 09.00.00.03, but this time the u-boot building fails when doing the binman job after compiling ...

I want CAN RX pin to trigger an interrupt and wake up the system from low power mode after receiving any data. How do I configure it? Is there a parameter setting like wake up function when requesting ...

I used G15 pin as RST signal to peripheral, its setting is: and test it voltage level after initialization periodly. static void enet_lwip_eth_rst(void) { uint32_t delayus = 100*1000; uint32_t ...

SCB is a read compare. So if you write "50 4a" to register 44 (accessing address 0x4a50) and read back the data from 0x4a50 then the value returned should be "2c 0e". SCB is to ensure data being ...

TCAN4550 nINT中断到M3连接如上图所示。 M3想尽快收到CAN总线上的报文，以减少TCAN4550转换带来的通信延迟。 1、这里想通过nINT中断方式通知M3，当有外部中断来的时候，在M3的外部中断中进行接收 ...

PFC驱动部分的，EPWM1-A和EPWM1-B起的什么作用？我看在程序里没有设置它的占空比？ 在Lab4中关于如下代码几个变量的理解 ...

We encountered some problems when using the 280039 ADC module, described as follows The ADC samples the AC voltage and finds that the sampling results are distorted, as shown below Purple channel: ADC ...

gst-launch-1.0 videotestsrc pattern=ball num-buffers=300 ! video/x-raw, width=3840, height=2160, framerate=30/1, format=NV12 ! queue !v4l2h264enc extra-controls ...

C2000ware 5.02 地址变量为：COM_TI_C2000WARE_INSTALL_DIR，CCS12.2以上版本能够直接匹配识别！ 但是C2000ware4.03版本地址变量为：COM_TI ...

BQ40Z50进入睡眠模式的条件是什么？ 另外，如果进入睡眠模式，CHSG FET 和 DSG FET 是否都关闭？ 如果检测到特定的电流，例如（-60mA，无通信），并且您希望电池进入睡眠模式或关机模式，应该怎么做 ...

3) Fakra Cable P/N#: 095FJZFJZSHM500 (Cable Assembly Coaxial Fakra to Fakra RG-174 196.9" (5.0m) 16.4') Also, please find attached screen shot for margin test result as well as schematic of serializer ...