I'm a beginner and I'm programming with Code Composer. I would like to know how to use the digital-to-analog converter with a 0 to 3.3V output. I can only get it to work from 0 to 3V. Do I need to ...

i've been working with the SK-AM62 EVM for a couple of processor sdk versions. Currently im switching to 09.00.00.03, but this time the u-boot building fails when doing the binman job after compiling ...

I want CAN RX pin to trigger an interrupt and wake up the system from low power mode after receiving any data. How do I configure it? Is there a parameter setting like wake up function when requesting ...

I used G15 pin as RST signal to peripheral, its setting is: and test it voltage level after initialization periodly. static void enet_lwip_eth_rst(void) { uint32_t delayus = 100*1000; uint32_t ...

SCB is a read compare. So if you write "50 4a" to register 44 (accessing address 0x4a50) and read back the data from 0x4a50 then the value returned should be "2c 0e". SCB is to ensure data being ...

TCAN4550 nINT中断到M3连接如上图所示。 M3想尽快收到CAN总线上的报文，以减少TCAN4550转换带来的通信延迟。 1、这里想通过nINT中断方式通知M3，当有外部中断来的时候，在M3的外部中断中进行接收 ...